The IC-F5330D/F6330D series offers a flexible and uniqueinstallation solution that allows the main unit (RF unit) and remote‑controller(PoE PD, Power over Ethernet Powered Device) to be connected using an Ethernetcable, and can be extended up to 100 m, 328 ft with an inexpensive Cat 5e LANcable. The remote-controller uses a Commandmic™ with excellent operability anda high contrast black LCD.
· 136–174, 400–520 MHz versions
· 128 Channels / 8 Zones
· Two-piece configuration –Commandmic™ + black box main unit
· Commandmic™ is powered from the main unit through an Ethernet cable*
* Extendable up to 100m, 328 ft. (Cat 5e LAN cable user supplied).
· High contrast, wideviewing angle, black background display on the Commandmic™
· 1700 mW (typical) audio output from the Commandmic™
· MIL-STD-810 G shock,vibration, temperature and more
· IPX4 water splash resistance for the Commandmic™
· DTMF autodial memoriescapability
· NXDN™ conventional
· NXDN™ Type-D single-sitetrunking
· NXDN™ simulcast
· NXDN™ multi-siteconventional over IP network
· Analogue mode
· PTT ID and ANI
· Over-the-Air Alias (OAA)displays the caller’s name without programming
· Individual, Group and Allcall
· Late entry for Group call
· Status call and Pollingcall
· Short data messages
· Call alert
· Radio check (RX only)
· CTCSS and DTCS tone
· 2-Tone and 5-Tone
· MDC functions; PTT ID,Emergency (TX/RX), Radio check (RX), Stun (RX), Revive (RX)
· BIIS PTT ID transmission
· Digital voice scrambler
· Emergency call and Lone worker
· Remote monitor (RX)
· Radio Kill, Stun andRevive (RX)
· Priority scan monitors on eor two priority channels while scanning non-priority channels
· Voting scan automatically selects the optimal repeater site
· Set an IP address for main unit andCommandmic™
· GPS receiver connection with optional ACC cable
· Optional D-SUB connector, OPC-2078/OPC-1939,for external PTT, channel, horn, ignition switch, and dimmer control, accordingto programming
Usinga PoE (Power over Ethernet) switch (as the power supply to the microphone) andan IP network, you can easily install the IC-F5330D series into abuilding*. In this installation scenario, you don’t have to worry aboutthe distance between the main unit and the Commandmic™. Also, as the main(RF) unit can be installed close to the antenna, cable loss is kept to aminimum.
* In-building usage is not available in some countries.